BeoLit Portable Radio
Production: 1974 - 12/1976
With the introduction of Beolit 600 in 1974, it also marked the end of this particular range of portable radios. After Beolit 505 / 707 were taken off the market, it was going to be a long while to wait until the introduction of BeoSound 3 almost three decades later.
Slim and very modern in appearance the radio was easy to use and light to carry around. Internally, it held its source of battery power and was able to receive FM, LW and MW radio bands offering 1W of undistorted sound.
Tuning was by way of sliding a pointer along a scale on the top of the unit and AFC was provided for the FM waveband. The FM band covered 87-5 - 104MHz, MW 186-587 meters, and LW 857-2040 meters
There were connections for record deck/tape recorder and an external loudspeaker as well as an external power unit.
Shown below are some of the original design sketches made by Jacob Jensen of the Beolit 600 Coloradio.
Types: 1501, 1504
FM 87.5 - 104 MHz
MW 520 - 1610 kHz, 578 - 186 m
LW 147 - 350 kHz, 2040 - 857 m
Power output >1.2 watts (distortion : 10%
Frequency Response 50 - 20,000 Hz (- 3 dB)
Distortion < 1% at 50 mW/1000 Hz
Impedance 4 ohms
Continuous Load 3 W
Frequency Response 60 - 15,000 Hz
Specifications: Dimensions W x H x D: 22 x 6 x 36cm
Weight 2.55 kg
Voltage: 7.5 volts (five 1.5 volt dry cells (33 x 60.5mm)
Connections: Inputs Gramophone
160 mV - 1000 Hz / 200 k ohms
Tape recorder: Sensitivity: 160 mV - 1000 Hz / 200 k ohms
External power supply: 7.5 V
Outputs Extension speaker - 4 ohms
Tape recorder: Output signal: max. 100 mV / 1000 Hz for 100 % modulation
Output impedance: 39 k ohms